Ives VR910M Uživatelský manuál stáhnout pdf

829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.

FOR USE WITH MORTISE DEVICES

VR910M/VR914M VANDAL RESISTANT TRIM

INSTALLATION INSTRUCTIONS

INSTALL MORTISE LOCK. SEE MORTISE LOCK

INSTRUCTIONS.

INSTALL EXIT DEVICE AND TRIM.

3

4

RHR

SHOWN

LHR

OPPOSITE

VR910M/VR914M

TRIM

SCREWS (4):

10-24 X 1”

PPHMS SCREWS

(1-3/4” DOORS)

10-24 X 1-1/2”

PPHMS SCREWS

(2-1/4” DOORS)

INSTALL CYLINDER, IF USING.

5

KEYHOLE

POSITION

WHEN INSTALLED

USE WAVE WASHERS

INSIDE CYLINDER

COLLAR AS NEEDED

FOR PROPER FIT

SET SCREW: REMOVE FROM CYLINDER

SIDE UNTIL CYLINDER IS SCREWED INTO

PLACE, THEN REINSTALL SCREW

CYLINDER COLLAR

3-1/2”

7”

3-1/2”

1-3/8”

13/32” DIAMETER HOLES,

4 PLACES (TRIM SIDE)

1/4” DIAMETER HOLES,

4 PLACES (OPPOSITE SIDE)

1-5/8” DIAMETER

HOLE (TRIM SIDE

OF DOOR) FOR

CYLINDERS ONLY

DEVICE & TRIM

HORIZONTAL

L

C

RHR SHOWN

LHR OPPOSITE

OUTSIDE FACE

OF LOCK STILE

11/16”

PREPARE PUSH SIDE OF DOOR FOR EXIT

DEVICE. SEE EXIT DEVICE INSTRUCTIONS

FOR PREPARATION.

PREPARE PULL SIDE OF DOOR FOR TRIM.

A TRANSFER VERTICAL AND HORIZONTAL

DEVICE CENTER LINES FROM PUSH SIDE

OF DOOR TO PULL SIDE.

B LOCATE AND PREPARE ALL HOLES AS

INDICATED BELOW.

1

2

DEVICE & TRIM

VERTICAL

L

C

2-1/4”

1

INSTALLATION INSTRUCTIONS 1

Shrnutí obsahu

Strany 1 - INSTALLATION INSTRUCTIONS

829560_00(2) Copyright © 2003 Ingersoll-Rand. All rights reserved.FOR USE WITH MORTISE DEVICESVR910M/VR914M VANDAL RESISTANT TRIMINSTALLATION INSTRUC

Komentáře k této Příručce

Žádné komentáře